|
| Wall Mounting and Fitting |
 |
|
Wall Mounting Instructions are included with every SolarVenti unit on how they may be installed on your house, holiday home, chalet or caravan etc.
Wall mounting any of the SolarVenti dehumidifier panels is actually far more straightforward and simple than most people realise, especially for the small to medium sized models.
Simply follow the instructions set out below:-
1) Locate the best place to install your SolarVenti (South, SE or SW facing with a minimum of shade from trees etc.) and mark the location for the inlet hole (110 - 132 mm depending on the SolarVenti model). You can then mount the lower two fittings (blue colour) with screws about 5 to 10 cm in from the side edge of frame.
The position of the air inlet valve is arbitrary, you can choose to mount the panel upwards, downwards or on either side.
2) Place the collector into the bottom fixings (blue colour) and tilt it towards the wall. Mark the upper edge with a pencil, or similar, and draw a line about 5 to 6 mm above this. The top fittings (red) can then be mounted along this line.
3) Cut through the wall to make your inlet hole as per the location that you marked in 1). If you do not have a rotary cutter of the relevant size an ordinary masonry drill can be used to cut multiple holes around the mark you have made.
4) Before the collector is finally mounted, fix the flexible tube to the outlet valve on the collector. Put the tube through the hole and fix it to the frame inside the house. Push the frame into the hole and fix it to the wall. You may wish to use some silicone sealant to prevent any air ingress around the hole (inside and outside). The white inlet valve may now be pressed into the frame. Turn clockwise to fix.
Now tighten the screws into the top fittings (red) to fully secure the SolarVenti panel to the external wall.
5) On/off switch:
The black and brown leads from the collector must be connected to the terminals in the switch. Press the red and black buttons in the switch and press the leads into the terminal. Release your hold and the leads will lock in place. The blue lead is not in use but you should protect it within the enclosed connecter unless you have also purchased a regulator (see 6.).
6) If you have an electronic regulator:
The three coloured leads should be mounted into the corresponding coloured terminals within the electronic regulator.
Full mounting instructions, including diagrams, are packaged with all SolarVenti dehumidifers at shipment.
Home Page. |
|
|
|
|
|
|
|
|
|
|
| Latest News |
|
|
|
|
|
|
|
|
|
| Contact us |
Telephone:
01782 791572 or on
08458 736359 (Local rate from anywhere within the UK)
Fax:
Please call and request number
eMail:
info@solarventi.co.uk
Our new address is:
Unit 14A
Moorfields Industrial Estate
Cotes Heath
Stafford
ST21 6QY |
|
|
|
|
|
|
|
| Products
|
There are six products in the SolarVenti range. Under ideal sunny conditions the smallest unit, the SV2 has a minimum airflow of 20m³/Hour whilst the largest, the SV30 unit has a minimum airflow of 120m³/Hour.
The newest product, the SV30H Plus, is a hybrid version of the SV30 which additionally provides Solar Water Heating. |
|
|
|
|
|
|
|
|
|
